- 14 -
Genoa difficult to hoist
- Poor output from a sheave.
Halyard jammed
- Try with a different halyard
PROBLEM ENCOUNTERED
CAUSES SOLUTIONS
Halyard turns with the halyard swivel
- Forestay not taut enough
- Genoa halyard too slack
- tighten the backstay
- tauten the genoa halyard
- Genoa halyard too close to the
forestay
- Fasten a halyard feeder to the mast
or a diverter to the forestay
The halyard tends to wrap itself - Halyard is worn and thus twists in - Change the halyard
Reefing line fouls
- Wrong angle on reefing line.
First sheave too far from drum unit.
- Change position of first sheave
- Slow down the unfurling of the
7/ OPTIONAL EXTRAS
7.1 - HALYARD DIVERTERS
When the genoa is furled or unfurled, if the angle between the halyard and the forestay is too tight, the halyard risks
being twisted round as the halyard swivel turns.
2 options are available to solve this problem:
7.1.1 : Halyard diverter wheel
To install the diverter wheel, it is necessary to dismantle the forestay
7.1.2 : Halyard feeder
To install the halyard feeder, it is not necessary to dismantle the forestay
2 sizes are available:
- ref 25677 : 609 et 811 models
- ref 26140 : 406 model
Ref : 25720
Ref : 25677 Ref : 26140
PANTONE Black
Offset 80g
58224_03 - Page 14/68
To Next Page
Loading...
Need help?
General
