Plextalk PTN2 - Inserting and ejecting SD card, USB memory and CD

17
2.9. Inserting and ejecting SD card, USB memory and CD.
To insert the SD card, do the following:
 Turn off the power.
 Hold the SD card so that the cut off corner may be located at
the front right corner. In other words, the cut off corner should
be nearest to the front side of the unit.
 Insert the SD card into the SD card slot on the left side of the
unit.
 Press the card all the way into the slot ensuring that it engages
properly, with the outer edge flush with the body of the
PLEXTALK. Do not use excessive force when doing so.
To eject the SD card, do the following:
 Turn off the power.
 Push the SD card inwards and then release it. The card
should pop out leaving the outside edge of the card protruding.
 Carefully grip the card and pull it out of the slot.
CAUTION: PLEXTALK's SD card slot is only compatible with SD or
SDHC cards. Inserting other memory card such as a Memory Stick
or MultiMedia Card, will cause a malfunction and should not be used.
Note: SD cards have a locking switch that enables you to protect
your data if you want. This is located on the longer side of the card
away from the cut off corner. If the switch is towards the leading
edge of the card, you will be able to back up and delete titles. If the
switch is away from the leading edge, your data will be protected.
To insert the USB memory, do the following:
 Turn off the power.
 Insert the USB memory into the USB slot.
To eject the USB memory, do the following:
 Turn off the power.