Section 2. Installing Your PX-708A Internal Drive
PX-708A Installation and Users Manual
17
NOTE
: The configuration shown in Figure 6 can make it very difficult to
write from the CD-ROM to the PX-708A at maximum rated speed using
“on-the-fly” copying.
System configuration and performance will make a big difference.
Depending on how fast the CD-ROM drive can stream data to the
PX-708A, it may not be fast enough to keep the buffer full. In this case,
the buffer may become empty and a buffer underrun error may occur.
However, because it is equipped with Buffer Underrun Proof Technology,
your PX-708A can still make successful copies if you use software that
supports this feature. (All software shipped with PX-708A drive retail kits
supports Buffer Underrun Proof Technology.)
If you still have problems writing with this configuration, use the image
writing method (that is, write an image to your hard drive, then write that
image onto the CD-R or CD-RW media), or record at a lower speed for
best results. We also recommend that DMA be enabled on your
computer, if your system supports it.
To Next Page
Loading...
