Plextor PX-708A - Make Sure Drive is Recognized

Section 2. Installing Your PX-708A Internal Drive
PX-708A Installation and Users Manual
31
Audio Connection Cable
Required
How to Connect It
MPC audio source MPC-
compliant
audio cable
Connect to MPC audio
source, and to analog audio
output connector at the rear
of the Plextor drive.
Sound Blaster or
compatible sound
board
Sound
Blaster-
compatible
analog audio
cable
Connect to Sound Blaster-
compatible audio board and
to analog audio output
connector at the rear of the
Plextor drive.
Digital audio output Cable that’s
compatible
with SPDIF
or Digital-In.
Connect to SPDIF or Digital-
In connector on sound
board (if sound board
supports digital audio) and
to digital audio output
connector at the rear of the
Plextor drive.
Make Sure the Drive Is Recognized
After installation, make sure the PX-708A drive and other IDE
peripherals are recognized by your computer. To check whether they are
recognized:
To see if the drive is recognized in Windows:
1. Turn the computer ON. After the computer boots up, you should see
the Windows display.
2. Open Windows Explorer or My Computer and ensure there is an
icon for the Plextor drive, the hard disk, and another CD-ROM drive,
if present. The Plextor icon may be D: or E: or another designator.