Section 2. Installing Your PX-708A Internal Drive
PX-708A Installation and Users Manual
21
About Cable Select
The Cable Select jumper position sets the PX-708A drive to use the
CSEL signal from the IDE interface for configuration purposes. This
signal automatically selects the correct Master/Slave setting for the
drive.
Figure 10: Configuring the PX-708A drive for Cable Select
To use CSEL, you must have:
•
A computer that supports CSEL.
•
A special CSEL (Cable Select) cable for IDE.
NOTE
: The IDE cable supplied by Plextor does
not
support CSEL. To
use CSEL and Cable Select, you’ll have to purchase a CSEL cable, or
use one that may be supplied with your CSEL-configured system.
To Next Page
Loading...
