Plinius 8150 instruction manual. Page 10
Choice of loudspeakers is one of personal taste, providing the chosen loudspeakers are suitable for use
with this control amplifier. Be certain that your loudspeakers can handle most of the rated output power
of this amplifier.
You may find your loudspeaker specifications confusing or misleading therefore you should discuss these
fully with your audio dealer prior to purchase. The use of higher power (100 Watts RMS or greater)
loudspeakers are recommended for this amplifier in stereo mode. Our experience indicates that low power
loudspeakers are quite often suitable for use with this amplifier provided the volume is maintained at a
level where no distortion is audible.
Impedance of the loudspeaker load is important to ensure the rated performance of this amplifier. Any
combination of loudspeakers may be used but the total average impedance load for each channel should be
within a range of 4 to 8 Ohms in stereo mode.
REMOTE CONTROL MAINTENANCE.
If the range of your Remote Control starts to diminish, your batteries may need replacing. To do this,
remove the two screws holding the bottom end cap, then slide the back panel out.
Please ensure batteries are replaced in the correct polarity.
SERVICING.
If the top cover of the 8150 amplifier is taken off for any reason, remove the mains supply
plug first. The Voltages present on the circuit board could be harmful.
In the unlikely event that your PLINIUS 8150 should require any service please take it
firstly to your Dealer in its original packaging. He will then determine if the unit should be
returned to the factory. Your PLINIUS Dealer has a good understanding of our
Amplifiers and will be able to advise on any further installation requirements.
CLEANING.
A damp cloth is all that is required to remove dust and finger marks from the 8150’s
anodised surface.
To Next Page
Loading...
