REP 2.17 Removal of Infeed Motor M6 assembly, Model 61
T08009 TJ
PURPOSE
By removing the infeed motor assembly you will have an easy access to the infeed motor and infeed
roller.
1. Switch off the main power switch and disconnect the power cord.
2. Remove Infeed covers, CRI 1.2
3. Disconnect the Infeed Motor M6 from the wire harness.
4. Remove the stud (1).
5. Push down the Infeed Motor assembly to by pass mode.
6. Push on the Infeed Motor assemble indicated in the drawing until it passes over the edge (2).
7. Move the Infeed Motor assembly left/right and lift out.
1
VIEW FROM TOP
Push here
VIEW FROM INFEED SIDE
Infeed motor
assembly
2
INSTALLATION
Installation is an exact reversed procedure of removal.
STAPLER FOLDER MODEL 60/61 PAGE 2.17 OCTOBER-94
To Next Page
Loading...
