0.00.114 PMDG 737NGX
TUTORIAL #2
27FEB15 RTM DO NOT DUPLICATE For Simulator Use Only
o On the SEL DESIRED OEV page, select the LSK 1L
option.
o Type /3.5 into LSK 2L to draw a 3.5nm ring around the
localizer.
Press NEXT PAGE
o Type OEJ and enter it at LSK 1L.
This is the localizer DME to the northeast of the airport
that is used in the missed approach procedure.
o On the SEL DESIRED OEJ page, select the LSK 2L
option.
o Type 247 and enter it at LSK 2L. (reciprocal of the 067
radial TO OEJ)
o Type 065 and enter it at LSK 3L
These last two lines set up the two course lines needed
for the missed approach procedure. We need two entries
to show both sides of the course that is used.
Press NEXT PAGE
o Type RTT and enter it at LSK 1L.
This is so we have RTT as a reference point during the
missed procedure as we need to hold there as the final
step in it.
We should now have the following FIX drawings set up:
Absam (AB) NDB with a 230 degree radial.
Innsbruck (INN) NDB with a 264 degree radial.
OEV localizer with a 3.5nm ring.
OEJ localizer with 247 degree and 065 degree radials.
RTT NDB, position only.
To Next Page
Loading...