Pneumercator ETD1000 - TMS Compatibility

ETD1000 Instruction Manual - 2017-07-01.docx Page 6 of 28 July 1, 2017
Figure 1.0-2 Interior View
1.1 TMS Compatibility
The ETD1000 can be used with any TMS2000, TMS3000, or TMS4000 provided appropriate
firmware is loaded. ETD1000 support is provided with the following TMS console firmware versions;
Vxx.99.90 thru Vxx.99.99
Vxx.00.xx
Vxx.01.xx
Vxx.02.xx
where “xx” denotes “don’t care” values
Please contact Technical Support for an upgrade if you have firmware outside of the above range,
or if you have questions about identifying the TMS firmware version in your console.
DWG NO. 20031 REV. A
6 8
7
1
5
4
3
2
DISPLAY CABLE
CONNECTOR
J1
DISPLAY
1/2 AMP
250 VAC
FAST
ACTING
GND
NEUTRAL
HOT
AC
IN
115V
D2D3
AUTO OFF
TMS FP ACK
AUDIBLE
CONTROL
EDIT ENABLE
S3
S4
LOGICAL
ADDRESS
1
2
3
4
5
6
7
8
O
U
T
I
N
RS-485 COMMS.
CH. A (+)
CH. B (-)
SHIELD
ON
OFF
LINE TERMINATOR
"ON" FOR
END-OF-RUN ONLY
TB2 T B3
S2
(2) LEDS
LINE TERMINATOR
SWITCH
(2) RS-485 COMMS.
PLUG-IN TERMINAL
BLOCKS
ROTARY
SWITCH
DIP
SWITCH
FUSE
LINE VOLTAGE
SWITCH
AC POWER PLUG-IN TERMINAL BLOCK
(W/ SCREW FLANGE TO SECURE PLUG)
+ 3.3 V + 5V
OPEN
COMM ALARM
MOTION DSP
D. PT. CTL
IMPORTANT! Confirm that the installed TMS console firmware version
supports ETD1000 communications.