3 User manual
English
Warnings
For your safety and to obtain an automation system with a correct operation,
make sure that the following conditions are met:
» The gate structure must be adequate for the automation system
» Make sure that the gates move correctly and evenly, without friction,
along the entire length of their path
» The wheels and rails of the gates must be in good condition, free of rust
and well greased
» The gates must be able to open and close freely, without obstacles
» It is recommended to install a gate stop for the open position
» DO NOT weld when the bearing is on the bearing sets, because it does
not have perfect contact with the bearings and they get burr trying to
make the table.
» DO NOT weld with the motor mounted, as the motherboard will heat up
and the wiring on the board will fail.
Safety information
» Do not replace components and accessories other than those included or
recommended by the manufacturer.
» Before powering the system, make sure that all connections and cables
are in good condition.
» Turn o the power when performing maintenance operations.
» Avoid the water control panel to avoid short circuits.
» Do not power the motor, control panel or other accessories directly to
the power source.
» Do not pass through the gates when they open or close.
» Keep the remote control in a safe place away from children.
» Read all information and warnings in this manual carefully before putting
the system into operation.
» During the installation of the automation system, take measures regarding
the safety of people and maintaining the integrity of the space in which
you work.
» The system has an overvoltage protection function to prevent damage to
the device or injuries.
» Install the automation system taking into account the weight, length and
To Next Page
Loading...
