Need help?Do you have a question about the PNI IP60 and is the answer not in the manual?
General| Output Frequency | 50/60Hz |
|---|---|
| Cooling | Fan |
| Operating Temperature | -25°C to +60°C |
| Storage Temperature | -40°C to +70°C |
| Rated output power | 6000W |
| Nominal AC voltage | 230V |
| Power Output | 6000W |
| Output Voltage | 230V |
| Protection Features | Short Circuit |
| Humidity | 5% to 95% (non-condensing) |
| Communication | RS485 |
Connects the camera's power cable to the included battery.
Connects the camera to a router for network access.
Press and hold to restore camera to default factory settings.
Warning: Ensure the SIM card's PIN code is deactivated before installation.
Insert Nano SIM and micro SD card into the camera's back cover slots.
Connect the power adapter from the battery to the camera and the solar panel to the battery.
Indicates solar charging activity: ON when charging, OFF when no sun.
Shows battery charge: Flashing Red (<=25%), Red/Green (<=50%), Green (<=75%, <=100%).
Indicates active output: ON when camera is powered, OFF when no output.
Use the CamHi app to add the camera by scanning QR codes or entering UID.
Connect phone and camera to the same network for advanced setup via RJ45 cable.
Search for camera on LAN, enter credentials, and view live images locally.
Access 4G settings, select network operator, and enter the correct APN for mobile data.
Verify SIM card, signal strength (>60), APN, and status codes for connectivity.
Set up SD card recording, activate Alarm SD REC, and enable recording schedules.
Enable motion-triggered recording for cameras with limited SD card capacity.
Install Search Tool, connect to router, and access camera through IP in IE.
Configure network parameters manually or enable DHCP for automatic IP assignment.
View live images, play recordings, and adjust settings using Internet Explorer.
Install HiP2P Client, add camera using UID or search, and access remotely.
Steps to attach the solar panel to its support and securely mount the camera.
Details sensor, resolution, lux, video/audio compression, lens, and Ethernet.
Information on GSM, P2P, and supported mobile/PC applications.
Specifies IR LEDs, white LEDs, and the camera's supply voltage.
Covers dimensions, IP66 rating, housing material, and working temperature.
Li-ion battery capacity/voltage and solar panel power/current ratings.
Details for the PWM solar charger and the 230V AC charger.
To Next Page
