15
GB
If the display flashes alternately with the heat setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you’re using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display “ ”will automatically disappear after 1 minute if no suitable
pan is placed on it.
Touch the ON/OFF control. After power
on, the buzzer beeps once, all displays
show “–” or “– –”, indicating that the
induction hob has entered the state of
standby mode.
Turn the whole cooktop o by touching
the ON/OFF control.
Beware of hot surfaces
H will show which cooking zone is hot to
touch. It will disappear when the surface
has cooled down to a safe temperature.
It can also be used as an energy saving
function if you want to heat further pans,
use the hotplate that is still hot.
OR
Finish cooking
To Next Page
Loading...