AFTER POWER-UP
As soon as the bread maker is plugged into the power supply, it lets out a
beep and “3:00” appears on the display after a short time. The two dots
between the “3” and “00” don’t flash constantly. The arrow points to 2.0lb
and MEDIUM. This is the default setting.
START/STOP
The button is used for starting and stopping the selected baking program.
To start a program, press the button once. There will be a
short beep and the two dots in the LCD begin to flash,
starts. Any other button is made inactivate
button after a program has begun. This feature
unintentional disruption to the operation of the program.
To stop the program, press the button for approx. 2 seconds.
A beep will sound, which means
PAUSE function
After a program starts, you can interrupt it at any time by pressing the
button once. The operation will be paused but the setting will
be memorized, the working time will flash on the LCD. The program will
continue after you touch button again or within 10 mins
without touching any buttons.
MENU
It is used to set dierent programs. Each time it is pressed (accompanied by
a short beep) the program will change. Press the button continuously, the 12
programs will be cycled to show on the LCD display. Select your desired
program. The functions of the 12 programs are explained as below.
kneading, rising, and baking normal bread. You may also add
ingredients to increase flavor.
kneading, rising, and baking within a longer rise time. The bread
baked with this program usually will have a crisper crust and light texture.
3. kneading, rising, and baking of whole wheat bread. It is
not advised to use the delay function as this can produce poor results.
4. kneading, rising, and baking a loaf with less time than Basic
bread. But the bread baked on this setting is usually smaller with a dense
and the program
except the
helps to prevent any
that the program has been switched o.
texture.
7
START/STOP
START/STOP
START/STOP
START/STOP
START/STOP
1.
2. French:
Whole wheat:
Basic:
Q uick:
To Next Page
Loading...
