2. If the display shows “LLL” after pressing the button (except
in the program BAKE), it means the temperature inside is too low
（accompanied by 5 beep sounds）, stop the sound by pressing the
button, open the lid and let the machine rest for 10 to 20
minutes to return to room temperature.
3. If the display shows “EE0” after you have pressed , the
temperature sensor is disconnected. Have the sensor checked by an
authorized expert.
Before first use
1. Please check if all parts and accessories are complete and free of damage .
2. Clean all the parts according to the latter section “Cleaning and
Maintenance”
3. Set the bread maker in baking mode and bake empty for about 10
minutes. After cooling it down, clean once more.
4. Dry all parts thoroughly and assemble them, so the appliance is ready for
use.
Operation
1. Place the pan in position and turn it clockwise until it clicks in correct
position. Insert the kneading blade onto the drive shaft. It is
recommended to fill holes with heat-resisting margarine prior to placing
the kneaders, this prevents the dough from sticking below the kneaders
and make removing the kneaders from bread easier.
2. Place ingredients into the bread pan. Please keep to the order mentioned
in the recipe. Usually, the water or liquid substance should be put first,
then add sugar, salt and flour, always add yeast or baking powder as the
last ingredient.
Note: refer to the recipe for the maximum quantities of flour and yeast which
may be used.
Yest or baking soda
Dry ingredients
Water or liquid
10
START/STOP
START/STOP
START/STOP
To Next Page
Loading...
