point Vitap - Recommendations for Operation; FAILURES AND SOLUTIONS

Rel. 03
53
4) Remove rear cover
5) lubricate the parts indicated by using the greaser
9.3 RECOMMEDNATION FOR GOOD FUNCTIONING
- Before starting to work, make sure that tools included in the equipment corresponds to those
actually installed on the machine
- Always check that the drilling speed are adequate, starting from lower speeds and gradually
increasing speed
- Place the correct mobile left shoulder, see chapter 6.2
CAP. 10 FAILURES AND SOLUTIONS
Low pressure - Increase pressure
Broken pipes - Replace the pipe
Broken pipes - Replace the f
Inadequate line voltage - Contact our assistance service
Defective pedal - Check and inform our assistance service
Opposite drilling head spindles rotation - Invert two phases in the line connection