Rel. 03
8
CHAPTER 3 SECURITY
3.1 GENERAL SECURITY RULES
A. The person in charge of the machine must be trained in the right use of the machine,
its safety devices and additional tools.
B. The drilling devices provided with the machine must be fastened and adjusted
correctly.
C. The machine must undergo ordinary and extraordinary maintenance procedures at
the requested frequency.
D. The person in charge of the machine must wear appropriate clothing according to
security regulations regarding the type of activity that shall be performed,
(protection gloves, shoes, protection eyeglasses). Always keep in mind to avoid
using bracelets, ties, garments that could get entangled.
E. Respect a sufficient safety distance input and output drilling at input and output
drilling machine.Before starting any operation w ith the machine, be sure that around
the working area (see chart XXX) people or any other obstacles that could be
sources of danger are away from it.
F. Always use protective gloves when changing or checking tool
G. Don’t place inflammables near the machine, possible sparks could cause fires or
explosions.
H. The person in charge of the machine must pay great attention when switching on
the machine.
I. The person in charge of the machine must always reflect upon possible
consequences before coming up to the most dangerous areas with his hands.
J. The machine must always be switched off when not in use.
K. Before using it it’s necessary to pay attention to the following warnings:
- Check the wear of the tools.
- In case of worn points, we suggest to replace them before using the machine
following the procedure described in the chapter “POINT
REPLACEMENT/ASSEMBLY”.
L. General cleaning of the machine, the workspace and the floor is an important
safety factor
To Next Page
Loading...