Rel. 03
7
THREE-PHASE +/-10 %
NETWORK FREQ. +/-2%
220 50/60
240 50/60
380 50/60
415 50
460 60
Using terms: room temperature 5-40°C. Humidity unti l 90% for a temperature of 20°C.
USING LIMITS
These machines have been designed to process the following materials:
1) solid wood
2) Panels of laminated and non-laminated chipboards
3) M.D.F.
4) Sundry compound materials, as long as they derive from wood
5)
Only the points in line with the features described in this handbook must be used.
2.4
MACHINE COMPOSITION
Drilling machine is provided with a non-assembled PC to make its shipment easier. The sale
standard composition is as follows:
Automatic multiple drilling machine equipped with:
• Customized PC and software
• 2+2 horizontal drilling spindles
• 8 vertical drilling spindles
• (OPTIONAL) n. 1 groove tool
• (OPTIONAL) n. 1 router tool
• Numerical control horizontal X axis (panel movement)
• Numerical control vertical Z axis
• Numerical control Y axis
• Machine lifting and transport system
The machine is provided with:
• a tool set
• operating system License
THIS MACHINE IS NOT DESIGNED TO BE USED WITH OTHER MATERIALS APART FROM
THE AFOREMENTIONED, ANY OTHER KIND OF USE OF THE MACHINE TO DRILL OTHER
MATERIALS AND WITH UNAPPROPIATE POINTS SHALL BE CONSIDERED AS AN
IMPROPER USE OF THE SAME. THESE MACHINES HAVE BEEIN DESIGNED AND BUILT TO
WORK IN SHELTERED INDUSTRIAL ESTABLISHMENTS, IF THE MACHINE IS WIRED UP IN
UNAPPROPRIATE ESTABLISHMENTS IT SHALL BE CONSIDERED AS AN IMPROPER USE
OF IT.
To Next Page
Loading...