Polaris Automatic Gate Operators 500 Single - Auto Close Timer Adjustment

Page
28
Auto Close Timer
The amount of time between opening the gate
and automatically closing the gate can be
adjusted between 0 seconds and 120 seconds.
The adjustment is made by
turning the
CLOSE TIMER potentiometer. The default
position of the potentiometer is zero seconds.
Timer will
activate after gates have completed one full
cycle. To increase the delay time, turn the
potentiometer
clockwise.
NOTE: Only active if Block 1, DIP switch 1 is
in the ON position.
POLARIS STRONGLY
RECOMMENDS THE USE OF A
SAFETY DEVICE SUCH AS:
PHOTO BEAMS OR SAFETY
LOOP WHEN AUTO CLOSE
TIMER IS ACTIVATED!