GENERAL INFORMATION
7.21
CONCENTRIC SWINGARM
MIDDLE AXLE REMOV
AL
1. Securely support rear of machine with middle
wheels off the floor. Remove middle wheels and
hubs.
2. Remove the rear chain gaurd.
3. Remove rear and middle drive chains.
4. Remove swing arm brackets from rear swing arm
weldment. Lower rear swing arm to the ground.
A
B
C
5. Remove retaining ring (A), nut retainer (B) and foam
seal (C) from right side of axle.
6. Loosen the jam nut witha13/4”StraightWrench
(PN 2870772).
D
E
To Next Page
Loading...
