GENERAL INFORMATION
3.34
OIL PUMP
REMOV
AL/INSPECTION
A
B
C
1. Remove pump shaft bearing (A) and thrust
washer (B) from pump shaft.
2. Remove (2) bolts holding pump drive gear (C).
3. Inspect drive gear teeth for cracks, damage or
excessive wear.
4. Remove three oil pump retaining bolts and pump.
5. Inspect mating surface of crankcase and oil
pump. Check for nicks, burrs, or surface
irregularities.
6. Remove the three screws and strainer screen
from pump.
7. Clean screen thoroughly.
8. Remove pump body screw and feed chamber
cover.
To Next Page
Loading...
