MAINTENANCE
2.35
Rear Axle:
Middle Axle:
3/8”--1/2” (6.77--12.70 mm)
3/8”--1/2” (6.77--12.70 mm)
Chain Deflection
Chain Deflection
Middle Axle:
3/8” -- 1/2 “ (6.77--12.70 mm)
Rear Axle:
3/8” -- 1/2 “ (6.77--12.70 mm)
SUSPENSION SPRING
PRELOAD
ADJUSTMENT
Center Spring
Adjustment Ring
2
1
Operator weight and vehicle loading affect
suspensionspringpreloadrequirements.Adjustas
necessary, using thespanner wrench (2) supplied
in your ATV tool kit to turn the adjustment cam (1).
FRONT SUSPENSION
G Compress and release front suspension.
Damping should be smooth throughout
the range of travel.
G Check all front suspension components for
wear or damage.
G Inspect front strut cartridges for leakage.
CENTER/REAR SUSPENSION
G Compress and release rear suspension.
Damping should be smooth throughout
the range of travel.
G Check all rear suspension components for
wear or damage.
G Inspect shock for leakage.
Shock Spanner Wrench
(PN 2870872)
CV SHAFT BOOT
INSPECTION
Inspect the cv shaft boots in the front of the ATV for
damage, tears, wear, or leaking grease. If the rubber
boot exhibits any of these symptoms, replace the
boot. Refer to Chapter 7 for CV boot replacement, or
have you Polaris dealer replace the boot.
Inspect Boots
To Next Page
Loading...
