Polaris 600 IQ LX - Page 54

51
THE PERFECT FIT
IQ & Switchback Rear Suspension Adjustments
Initial Spring Preload Setting (Sag Method)
To determine sag, commonly referred to as ride-in, subtract measure-
ment Y from X (sag=X-Y). If the measured sag is incorrect, adjust the
FRA position and/or rear torsion spring preload.
NOTE: This is only an initial setup, and final spring preload may vary
based on rider preference and riding conditions.
Suspension Recommended Sag Adjustment
See
Page
IQ (121) 4-5 inches (10-13 cm) Torsion Spring
Preload
52
SwitchBack
(136)
4-5 inches (10-13 cm) Torsion Spring
Preload
52