69
PRE-RIDE INSPECTIONS
Before Starting the Engine
Brakes
Always check the following items for proper operation before starting
the engine.
Brake Lever Travel
NOTICE: Do not pump the brake
lever when performing
this procedure.
Squeeze the brake lever. It
should move no closer to the
handgrip than 1/2 inch (1.3
cm). A smaller distance
indicates low brake fluid level
or air in the hydraulic system.
Refer to the brake bleeding
information on page 112 or see
your dealer for service.
Lever Feel
If the brake lever feels “spongy” when squeezed, check the brake fluid
level and condition. Add fluid as needed. See page 111.
WARNING! Continued use of “spongy” brakes may cause a complete loss of
brakes, which could result in serious injury or death. Always have the brakes
serviced at the first sign of sponginess.
Brake Fluid Level
Position the handlebars so
the brake fluid reservoir is as
close to level as possible.
View the fluid level through
the reservoir (shaded in
illustration). If the level is
below the MIN (minimum)
level specification, add
POLARIS DOT 4 brake
fluid. See page 111.
1/2” (1.3 cm)
To Next Page
Loading...
Need help?
General
