Polaris Axys 2015 800 RUSH - Handlebar Component Torques

60
THE PERFECT FIT
Handlebar Adjustments
Riser Angle
Riser angle can be adjusted to suit rider preference. Factory settings are
shown below.
1. Loosen the four bolts on the bottom of the adjuster block. If
necessary, pry the blocks apart with a screwdriver.
2. Adjust the riser forward or rearward to the desired position.
3. Tighten the bolts to 14.8 ft-lbs (20 Nm).
PRO-S Models - 0° PRO-X Models - 11° Forward