85
OPERATION
POLARIS Electronic Reverse (PERC)
Engaging Reverse
1. Stop the snowmobile and leave the engine idling.
2. Make sure the area behind your vehicle is clear.
3. Push the yellow reverse button on the left-hand control for one
second, then release. The engine will automatically reduce RPM
and start a reverse rotation. A flashing reverse light on the
instrument panel will indicate that the snowmobile is in reverse.
4. Apply the throttle slowly to make sure the snowmobile is in
reverse.The maximum engine RPM will be 6000 when in reverse.
TIP:If the engine stops running, the snowmobile will be in forward gear when it's
restarted.
Disengaging Reverse
1. Stop the snowmobile and leave the engine idling.
NOTICE: Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the snowmobile is in reverse. Never
engage the starter when the engine is running.
2. Push the yellow reverse button for one second and release. The
engine will slow and begin to rotate forward. The light on the
instrument panel will shut off.
3. Apply the throttle slowly to make sure the snowmobile is in
forward.
To Next Page
Loading...
Need help?
General
