BODY 7 - 6
INSTALLATION OF SCUFF GUARDS
1. 2 Pass
• Once all the panel bolts are tightened then
the scuff guard can be assembled.
• Measure down from bolt number three on the
front side panel 3-1/2 inches.
2. Mark the hole location
• Measure ½ inch from the seam of the panel
to get front bolt hole location.
• Drill out the hole to accommodate the bolt.
3. Place the scuff guard
• Set the scuff guard on the car and insert the
front bolt that has just been drilled.
November 2007 GEM Service Manual
To Next Page
Loading...
