BODY 7 - 20
POD COVERS
DESCRIPTION
The Pod Covers are used to protect and house the
components of the steering column. They are
secured in place by 6 screws, 4 on the RH side of
the steering column and 2 on the front surface.
Fig. 16 Pod Cover
1 - Cowl left hand 3 - Screw
2 - Cowl right hand 4 - Plug screw cover
REMOVAL
1. Remove the upper and lower dash assemblies.
See upper and lower dash in this section.
2. Remove the 2 screw covers on front of the
instrument Pod.
3. Remove the 2 front pod cover screws.
4. Remove the 4 screws located on the sides, and
remove the Pod covers.
INSTALLATION
1. Install 4 screws in located on the sides, and
remove the Pod covers.
2. Install the 2 front pod cover screws.
3. Install the 2 screw covers on front of the
instrument Pod.
4. Install the upper and lower dash assemblies.
See upper and lower dash in this section.
November 2007 GEM Service Manual
To Next Page
Loading...
