BODY 7 - 8
INSTALLATION OF SCUFF GUARDS (CONTINUED)
7. Mark the hole location
• Measure ½ inch from the seam of the panel
to get your front hole location.
• Drill out the hole to accommodate the bolt.
8. Locating the scuff guard
• Insert the front bolt to locate the scuff guard.
9. Finishing the scuff guard
1. Drill out the remaining two boltholes.
• Insert the bolts.
• Tighten the fasteners just tight enough to
not deform the scuff guards.
November 2007 GEM Service Manual
To Next Page
Loading...
