109
Maintenance
Engine Oil Change
8. Clean the pre-filter plug. Install a new sealing washer on the plug. The sealing surfaces
on the plug and crankcase should be clean and free of burrs, nicks or scratches.
9. Reassemble the pre-filter screen and spring to the pre-filter plug.
10. Reinstall the pre-filter drain plug. Torque to 11 ft. lbs. (15 Nm).
11. Remove the dipstick. Add 29 oz. (850 ml) of the recommended oil. Do not overfill. See
the specifications section beginning on page 158 for capacities.
12. Reinstall the dipstick.
13. Start the engine. Allow it to idle for one to two minutes.
14. Stop the engine and inspect for leaks.
15. Check the oil level. Add oil as needed to bring the level to the upper mark on the
dipstick.
16. Dispose of used oil properly.
To Next Page
Loading...
Need help?
General
