117
Maintenance
CVT Drying
There may be some instances when water is accidently ingested into the CVT system. Use
the following instructions to dry it out before operating. The drain plug is located on the
bottom of the CVT cover.
1. Remove the drain plug. Allow the water to drain. Reinstall the drain plug.
2. Shift the transmission to neutral.
3. Start the engine. Apply varying throttle for 10-15 seconds to expel the moisture and air-
dry the belt and clutches. Do not hold the throttle wide open for more than 10 seconds.
4. Allow the engine RPM to settle to idle speed.
5. Test for belt slippage. If the belt slips, repeat the process.
6. Your vehicle requires service as soon as possible. See your POLARIS dealer or other
qualified service facility for service.
NOTICE: Exposure to salt water will cause corrosion to metal components. If your vehicle is operated
in salt water areas, rinse it off frequently with fresh water.
To Next Page
Loading...
Need help?
General
