146
Maintenance
Battery
Battery Installation and Connections
Always install a fully charged battery. Using a new battery that has not been fully charged
can damage the battery and result in a shorter life. It can also hinder vehicle performance. If
recharging is necessary, use a .5 amp battery charger
1. Set the battery in its holder.
2. Coat the terminals with dielectric grease or petroleum jelly.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Attach the hold-down strap.
6. Verify that cables are properly routed.
To Next Page
Loading...
Need help?
General
