31
FEATURES AND CONTROLS
Malfunction Indicator Troubleshooting Guide
The malfunction codes will blink on the controller. The code definitions
provided here are for informational purposes only.
Tip: If the indicator illuminates due to a minor issue such as a low voltage condi-
tion or a sequence fault (reversing direction without releasing the accelera-
tor, turning the key on while in forward or reverse), select neutral and turn
the key off and on to clear the error. If the error does not clear, please see
your POLARIS dealer for diagnosis and repair.
Charge Status Indicator Troubleshooting Guide
The code definitions provided are for informational purposes only.
Please see your POLARIS dealer for diagnosis and repair.
# of Blinks Code Definition
Steady Key was turned on in forward or reverse (switch to
neutral, then to forward or reverse)
1 Data or configuration error
2 Sequence fault
3 Power fault
4 Contactor issue
6 Throttle input error
7 Voltage protection
8 Controller or motor out of temperature range
13 Software fault
# of
Blinks
Code Definition Solution
1 Battery high voltage Check battery size and condition;
reset charger (interrupt AC power
for 15 seconds)
2 Battery low voltage
3 Charge time-out, battery pack
not reaching required voltage,
charger output reduced due to
high temperatures
Check connections; operate
charger at lower ambient
temperature
4 Battery could not be trickle-
charged to minimum voltage
Check battery for shorted or
damaged cells
5 Charger shut down due to
overheating
Ensure sufficient cooling air flow
(open the hood) and reset the
charger (interrupt AC power for 15
seconds)
6 Charger internal fault Reset charger (interrupt AC power
for 15 seconds); return to qualified
service provider if fault persists
To Next Page
Loading...
Need help?
General
