50
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Diagnostic Mode
The wrench icon will display when the gauge is in the diagnostic mode.
To exit the diagnostic mode, turn the key switch off and on. Any move-
ment of the tires will also cause the gauge to exit the diagnostic mode.
To enter the diagnostics mode:
1. Turn the key switch off and wait 10 seconds.
2. Place the transmission in neutral.
3. Hold the mode switch and turn the key switch on. Release the
switch as soon as the display is activated.
4. Use the mode switch to toggle through the diagnostic screens.
Clock Screen
To reset the clock:
1. Enter the diagnostic mode. Toggle to the clock screen.
2. Press and hold the mode switch until the hour display flashes.
Release the switch.
3. Press and release the mode switch once to advance the setting by
one hour. Press and hold the mode switch to advance the hours
quickly.
4. When the desired hour is displayed, wait approximately four sec-
onds, until the minute display flashes.
5. When the display stops flashing, the mode has been set.
6. Use the same procedure to reset the minutes.
Battery Voltage Screen
View this screen to check battery voltage level.
Tachometer Screen
View the tachometer to check engine speed.
To Next Page
Loading...
Need help?
General
