97
MAINTENANCE AND LUBRICATION
Cleaning and Storage
Storage T ips
Fog the Engine
1. Treat the fuel system with Polaris Carbon Clean, following the
instructions on the can. Run the engine for several minutes so the
Carbon Clean reaches the injectors. Turn the engine off.
2. Remove the spark plugs and add 2-3 table spoons of Premium 4
Synthetic 0W40 engine oil. To access the plug holes, use a section of
clear 1/4” hose and a small plastic squeeze bottle fille d with the
pre -me asur ed amount of oil.
NOTE: Do this carefully! If you miss the plug holes, oil will drain from
the spark plug cavities into the hole at the front of the cylinder
head, and appear to be an oil leak.
3. Reinsta ll the spark plugs. Torque to spec ifica tion. See page 70.
4. Apply dielectric grease to the inside of each spark plug cap and
re install the ca ps onto the plugs.
5. Turn the engine over sever al times. Oil will be for ce d in and ar ound
the piston rings an d ring lands, coating the cylinde r with a prote ctive
film of fre sh oil.
6. If Polaris fuel system additive i s not used, fuel tank, fuel lines, and
injectors should be completely drained of gasoline.
Battery Maintenance
Remove the battery and recharge it fully. Store the battery in a cool,
dry place.
Engine Anti-Freeze
Test engine coolant strength and change if necessary. Coolant should
be replaced every two years.
Storage Area/Covers
Be sure the storage area is well ventilated, and cover the machine with a
genuine Polar is cove r.
NOTE: Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote
corrosion and oxidation.
To Next Page
Loading...
Need help?
General
