83
MAINTENANCE AND LUBRICATION
Brakes
Brake Inspection
5. Check the brake system for fluid
leaks.
6. Check the brake pedal for excessive
travel or a spongy feel.
7. Check the friction pads for wear,
damage and looseness.
8. Inspect the brake disc spline and
pad wear surface for excessive wear.
9. Change pads when worn to 3/64″
(1 mm).
Park Brake Insp ectio n
1. Slowly push the park brake pedal
down with your foot.
2. After 8 to 12 clicks of pedal
travel, check the vehicle for
movement. The vehicle should
not roll while parked. If the
vehicle moves, adjustment is
necessary.
Park Brake Adjustment
1. Position the vehicle on a level surface.
2. Shift the transmission to neutral.
3. Loosen or tighten the nuts on t he
pedal end of the park brake cable as
needed.
3/64″ (1 mm)
1
To Next Page
Loading...
Need help?
General
