114
TROUBLESHOOTING
Engine Troubleshooting
Problem Probable Cause Solution
Noise in drive
system
Broken drive clutch
components
Bearing failure/
chaincase, jack-
shaft, or front drive
shaft
Drive belt surface
flat spots
Drive chain loose
or worn, sprocket
teeth broken
- SEE YOUR DEALER.
- SEE YOUR DEALER.
- Inspect and replace if necessary.
- Inspect and adjust or replace.
Poor low RPM
performance
Worn drive belt
Excessive belt/
sheave clearance
Loose torque stop
Sticky clutch
- Inspect and replace if necessary.
- SEE YOUR DEALER.
- Inspect and adjust.
- SEE YOUR DEALER.
Engine doesn’t
start (electric
start models)
Wire connections - SEE YOUR DEALER.
Engine doesn’t
turn
Seized engine
Hydrostatic lock
- SEE YOUR DEALER. Seizure is a result
of poor lubrication, inadequate fuel supply,
broken parts, or improper cooling.
- Fuel may have entered crankcase while
vehicle was standing or being transported.
SEE YOUR DEALER to correct cause.
Drain plug(s) are located on lower
crankcase for emergency draining.
To Next Page
Loading...
