47
PRE-RIDE INSPECTIONS
Start the Engine and Check
n Engine Stop Switch: Check the auxiliary shut-off switch for
proper operation. Push down to stop the engine. Pull up to release
and start the engine.
n Lighting Check: Check the headlight (high and low beam),
taillight, and brake light for normal operation.
n Mirror Adjustment: If equipped, adjust your mirrors so they can
be used to their full advantage.
n Check Surroundings to Verify Clear Operating Area
Make sure you have a clear area all around your snowmobile, including
an area clear of bystanders. There’s always the possibility of some
sideways vehicle movement, of applying a little more throttle than
intended, or of debris being t hrown by the track. If the surrounding
area is clear you before you start, you can devote your full attention to
operating the snowmobile.
Inadequate cooling and lubrication will lead to overheating of the
slide rail and track, resulting in premature wear and failure.
Reduce speeds and frequently drive into fresh snow to allow
adequate cooling and polishing of the slide rail and track surfaces.
Avoid operating on ice, hard-packed surfaces or roads.
CAUTION
To Next Page
Loading...
Need help?
General
