33
SAFETY
Safety Decals and Locations
Warning decals have been placed on the ATV for your protection. Read
and follow the instructions of the decals on the ATV carefully. If any
of the decals depicted in this manual differ from the decals on your
ATV, always read and follow the instructions of the decals on the ATV.
If any decal becomes illegible or comes off, contact your Polaris dealer
to purchase a replacement. Replacement safety decals are provided by
Polaris at no charge. The part number is printed on the decal.
7079604
WARNING
Pushing reverse
override button
may cause
sudden increases
in power and
traction if too
much throttle is
applied. Loss of
control or forward
flipover may
result, especially
in AWD. See
Owner’s Manual.
DNever operate this vehi cle on HILLS steeper than 25 degrees
To prevent flipover on hilly terrain, when going up or down, use throttle
and brakes gradually.
DREVERSE operation can be dangerous, even at l ow speeds. Steering be-
comes diffi cult. To prevent flipover, avoi d sudden braking or sharp turns.
DUse OVE RRIDE for reverse speed limiter with caution. To prevent loss
of control, never activate override button with open throttl e.
DPARKING BRAKE may relax when used for more than 5 minutes. When
parking on grades, leave shift in forward.
WARNING
7079085
25°
.
S Moving par ts haz ard under belt-clutc h guar d. To
prev ent s er ious injury, do not oper ate v ehicle
with guard remov ed.
S Do not modify engine or clutch. Doing so can
cause part failure, possible imbalance, and
excessive engine RPM, which can result in serious
injury or death.
NO STEP
7078689
WARNING
To Next Page
Loading...
Need help?
General
