84
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
Drive Chain
Polaris ATV drive chains are equipped with o-ring-seal ed, permanently
greased pins and rollers. However, the outer surfaces of the roller must
be lubricated.
Always inspect the drive chain prior to operating the vehicle. Check for
damaged or missing o-rings or damaged rollers. Also check for correct
slack adjustment. Maintain the stone guard to rear sprocket clearance
at 1/8″ (.3 cm).
Regularly lubricate the drive chain with Polaris Chain Lube, an SAE
80-90 lube or an approved o-ring chain spray lube. See page 117 for the
part numbers of Polaris products.
Washing the drive chain with a high pressure washer or gasoline
can cause damage to the o-rings, causing premature wear and
drive chain failure. Do not use a high pressure washer or
gasoline to clean the drive chain.
CAUTION
To Next Page
Loading...
Need help?
General
