50
OPERATION
Pre-Ride Inspection
Use the following checklist to verify that your ATV is in proper
working condition before each use.
Item/Inspection Procedure
1. Tires - Check condition and pressures.
2. Fuel and oil tanks - F ill both tanks to their proper l evels.
3. All brakes - Check operation, adjustment and fluid level (includes
auxiliary brake).
4. Throttle - Check for free operation and closing.
5. Headlight/Taillight/Brakelight - Check operation of all indicat or
lights and switches.
6. Engine stop switch - Check for proper function.
7. Wheels - Check for tightness of wheel nuts and axle nuts; check
that axle nuts are secured by cotter pins.
8. Drive chain - Check condition and slack (refer to drive chai n
adjustment section); lubricate when needed.
9. Air cleaner element - Check for dirt; clean or replace.
10. Steering - C heck for free operation, noting any unusual looseness
in any area.
11. Loose parts - Visually inspect vehicle for any damaged components
or loose nuts/bolts or fasteners.
12. Riding gear - Wear a helmet, goggles and protective clothing.
13. Engine coolant - Check for proper level at the recovery bottle.
If a proper inspection is not done before each use, severe
injury or death could result. Always inspect the vehicle before
each use to ensure it’s in proper operating condition.
WARNING
To Next Page
Loading...
Need help?
General
