81
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
Oil and Filter Change
9. Place shop towels beneath the
oil filter (1). Using an oil filter
wrench, t urn t he filter
counterclockwise to remove.
10. Using a clean, dry cloth, clean
the filter sealing surface on the
crankcase.
11. Lubricate the gasket on the new
filter with a film of new engine
oil. Make sure the gasket is i n
good condition. Also make sure the gasket from the old filter is
not still on the engine.
12. Install the new filter and tighten by hand 1/2 to 3/4 turn after the
gasket contacts the engine.
13. Approximately one cup of engine oil will remain in the crankcase
sump. To drain, remove the drain plug on the lower right side of
the crankcase. Reinstall the drain plug after draining.
NOTE: The sealing surfaces on the drain plug and crankcase
should be clean and free of burrs, nicks or scratches.
14. Remove the dipstick (2) and add the recommended oil. NOTE: If
the sump i s not drained, add about 1 3/4 quart s (1.66 l) initially.
15. Reinstall the dipstick.
16. Place the gear selector in neutral and set the parking brake.
17. Start the engine and l et it idle for one to two minutes. Stop the
engine and inspect for leaks.
18. Re-check the oil level on the dipstick and add oil as necessary to
bring the level to the upper mark on the dipstick.
19. Dispose of used filter and oil properly.
2
1
Loss of oil pump prime could result in engine damage. It’s
extremely important to drain, refill and start the engine in an
expedient manner. Do not allow the engine to sit without oil
for extended periods.
CAUTION
To Next Page
Loading...
Need help?
General
