3 Press the Label button to display a blinking cursor (c) under
the first empty space in the LCD panel label field.
4 Press the Erase button once to erase the last character of the
label, twice to erase the last two characters, etc. To erase the
entire label, hold the Erase button for 3 seconds or longer.
If no picture label exists, it is not necessary to press the Erase
button.
5 To insert a new character at the cursor location, press the
Scroll button until the desired character appears in the label
space. Press the Enter button to store the character and move
the cursor to the next space.
To leave a blank space, press the Enter button without
entering a character.
6 Repeat step 5 until you have completed the new label (up to
10 characters and spaces).
7 Exit from the Label mode by pressing the Label button.
54
To Next Page
Loading...
