Expert preferences You can choose to transfer pictures from
the camera to an image processing application or directly to a
file on disk, to keep the PDC-2000 plug-in active or close it
after each transfer operation, and to disable display of
thumbnail images from the camera for faster plug-in launch.
Changing the preferences To change any of the preference settings described above:
1 Connect the PDC-2000 camera to the computer as described
on page 17.
WARNING: DO NOT CONNECT OR DISCONNECT THE
PDC-2000 CAMERA OR ANY OTHER SCSI DEVICE
WHILE THE DEVICE OR YOUR COMPUTER IS TURNED
ON. DOING SO COULD DAMAGE THE DEVICE, YOUR
COMPUTER, OR BOTH.
2 Turn on the camera by pressing the Power button (a).
3 Turn on the computer.
4 Start an image-processing application compatible with
Photoshop plug-in modules or start Polaroid PDC-2000
Direct.
5 If you are using PDC-2000 Direct, skip to step 6.
If you are using an image-processing application, choose
Acquire from the File menu, then choose PDC-2000.
Using the PDC-2000 with your Macintosh 77
To Next Page
Loading...
