Using Poly Studio R30
Topics:
▪ Set Poly Studio R30 as the Default Audio and Video Device
▪ Tracking Modes
▪ Connect Poly Studio R30 to a Bluetooth Device
▪ Reset Your Device
▪ Factory Restore Poly Studio R30
▪ Restart Your Device
▪ Using the Remote Control
Once you plug in the power cable, you can start using the Poly Studio R30 device.
Connect the Poly Studio R30 device to your laptop or computer with the USB cable. Additionally, you can
also connect it to your Bluetooth host devices.
Set Poly Studio R30 as the Default Audio and Video
Device
If you use the Poly Studio R30 device with a supported application for video calls, you may need to set
Poly Studio R30 as the default audio and video device of your application.
The following is a general procedure that you can refer to. Your application may use different terms or
categories.
Procedure
1. Go to your conferencing application’s Settings.
2. Find Audio Device and Video Device.
3. Choose Poly Studio R30 as the device for each category and select Save.
Important: Make sure you use the same Poly Studio R30 audio source. If you connect the Poly
Studio R30 device to a computer over USB and Bluetooth at the same time, make
sure you use the USB option for both audio settings.
Tracking Modes
Besides the general speaker tracking mode, Poly Studio R30 provides more modes for specific scenarios
like conversations or presentations.
Note: You can enable only one mode at a time.
9
To Next Page
Loading...
Need help?
General
