Switch between calls (flash)
To switch between calls:
• Double-press the headset Call .
NOTE Switching 2 desk phone calls can only be done from your desk phone.
Smart sensors respond when you put on or take off your headset. Customize in Poly Lens
App. Below describes default settings.
With active sensors putting on the headset will: taking off the headset will:
Mobile/softphone call answer the call keep call in headset
Music/media resume music/media (if
playing previous to taking off)*
pause music/media (if
playing)*
Lock headset unlock the Call button lock the Call button to avoid
accidental calls
NOTE *Functionality varies by application. May not function with web-based apps.
Reset sensors
You may need to reset the sensors if they are not working as expected.
• Wearing the headset, tap the Call
button to test sensors. A talk time voice alert means
sensors are working. A tone or lack of voice prompts means sensors need to be reset.
• To reset the sensors, power on the headset, connect the headset to a USB cable and plug
the cable into your computer's USB port or an AC wall adapter (not included). Then place
the headset on a flat, non-metallic surface for more than 10 seconds.
• If you don't have your charging cable available you can also reset your sensors by first
turning off the headset, then pressing and holding the Call and Mute buttons
simultaneously until the LED turns off. Then put on your headset and turn it on.
Disable sensors
• You can disable your headset smart sensors in Poly Lens App or by using a button press
while your headset is idle. Simultaneously press and hold the Call and Mute buttons for
5 seconds. You hear "smart sensors off."
Use sensors
13
To Next Page
Loading...
