Your system has a base and compatible Bluetooth headset.
Your headset comes pre-paired to the base. To pair again:
1 Press the headset Call button until you hear "pairing" and the headset LEDs flash blue and
red.
2 Put your base into pair mode by pressing and holding the Bluetooth pairing
button on the
back of your base for 2 seconds until the display panel's Bluetooth icon flashes blue and
red.
Pairing is successful when you hear "pairing successful" and "base connected" and the
display panel's Bluetooth icon turns solid blue.
NOTE Your headset can pair with up to 8 devices but only maintain 2 connections
simultaneously; this includes the base.
1 To put your headset in pair mode, press the Call button until you hear "pairing" and the
headset LEDs flash blue and red.
2 Activate Bluetooth on your phone and set it to search for new devices.
• iPhone Settings > Bluetooth > On*
• Android Settings > Bluetooth On > Scan for devices*
NOTE *Menus may vary by device.
3 Select “PLT V5200 Series.”
Once successfully paired, you hear “pairing successful” and the headset LEDs stop flashing.
NOTE Your headset can pair with up to 8 devices but only maintain 2 connections
simultaneously; this includes the base.
With your headset powered on, press the Call button until you hear "pairing."
Pair
Pair headset to base
Pair to mobile device
Pair mode
8
To Next Page
Loading...
