Polyaire ZoneMaser ZoneTouch V2 - Adjusting Airflow for a Group; Automated Group Control

ZONEMASTER ZONETOUCH V2 ZONE CONTROL SYSTEM - User Manual
5
4) Automated Group Control
 Automatedon/ocontrolforeachgroupisanimportantfeatureoftheZoneTouchV2
 system.Thissystemhasthreeprogramscenarios,oneforweekdays(Mondayto
 Friday),oneforSaturdayandoneforSundayrespectively.
Eachprogramscenariohas4programmableeventsperday:ontime1,otime1,on
 time2andotime2.Eachprogrameventcanbeenabledanddisabledandthetime
 canbeadjustedasdesired.Allfoureventsaredisabledinthefactorydefaultwith
 settingsaslistedinthetablebelow.Userscancreateupto4programsusingthe
 scenariosanddierenteventtimeslots.
NOTE: A group can have up to a maximum of 4 zones. Your installer would
have already set up your zones and groups.
3.2  Adjustingairowforagroup
•Thedamperopeningpercentageforeverygroupcanbeadjustedtocontrol
theamountofairowateveryoutletbetween10%and100%ofthebalanced
value(setupbyInstaller)at10%increments.
   • Touch or buttons on the home screen to increase or decrease the
percentage opening for the corresponding group.
•TheairowwillbeunadjustableiftheTurbofunctionisactive.Pressing
andwillnotchangetheopeningpercentage.
NOTE: The Turbo function cannot be programmed. It is activated manually from
the touch screen as needed.
On time 1 O time 1 On time 2 O time 2
Monday to Friday
6.30AM 8.00AM 5.30PM 10.00PM
Saturday
7.30AM 12.30PM 6.00PM 11.30PM
Sunday
7.30AM 12.30PM 6.00PM 11.30PM