Page 16
Dial Sequences
A dial sequence is the chain of events that occur whenever your extension is dialed. Dial sequences are arranged into two
categories:
Default Dial Sequence: This is a simple two-step configuration that is suitable for most generic extensions. Normally an
extension rings four times, and then goes to voicemail.
Alternate Dial Sequence: This is a more advanced configuration that can be extended to six steps. It enables complex
find-me / follow-me rules to be defined in which the extension dials around to various locations.
Attribute Description
Always Enabled This enables the Alternate Dial Sequence and disables the Default Dial Sequence on a permanent basis
Enabled on . . . This enables the Alternate Dial Sequence and disables the Default Dial Sequence on a scheduled basis
Disabled on . . . This disables the Alternate Dial Sequence and enables the Default Dial Sequence on a scheduled basis
Always Disabled This disables the Alternate Dial Sequence and enables the Default Dial Sequence on a permanent basis
Note: For more information on Scheduling and Configuring Dial Sequences please refer to your Fibernetics Digital PBX
Training Manual
To change your Alternate Dial Sequence settings:
1. Press the More soft key to locate the Alt DS soft key
2. Press the Alt DS soft key
3. Follow the voice prompts
To Previous Page
Loading...
Need help?
General