2 Getting to know your Hosted PBX system
Before you Begin Your Installation
The DPS FLEX phone system is designed to use your existing
broadband data connection as well as the existing data wiring in
your office. Where you don’t have data wiring, you may use the
optional Base Unit and Wireless Adapters to connect Conference
Phones to the Base Unit wirelessly. In order to begin using your
new phone system and service, you need to perform the following
steps:
1. Make sure you have received all of your phones and
optional equipment
2. Go to www.accessline.com/login. Enter your login
name and password to the Admin Portal
3. Activate your phone lines
4. Install your phones and optional equipment
You have several options regarding how to setup your new phone
system. How you choose to install your phone system will depend
on your existing data network and the phones and optional
equipment you have purchased. The diagram below describes
options for setting up the phone system. By purchasing the optional
Wireless Transmitter and Wireless Adapters you may also connect
Conference Phones wirelessly.
• To create a new Call Park Group:
• Enter the name of the Call Park Group
• Click Save
• A Paging Group Number will be automatically
assigned. Once the Paging Group has been
created, a new column will appear in the table.
Check the button associated with the phone you
want included in this Call Park Group. A phone
can only be in one Call Park Group.
To Next Page
Loading...
