Holding and Resuming Conferences
When you place a conference call on hold, you place all other
conference participants on hold.
To place a conference call on hold:
From the Active:Conference screen, press the Hold soft key.
The Hold:Conference screen displays. The other parties in the
conference call are put on hold.
From the Hold:Conference screen, you can do the following:
• To resume the conference call, press the Resume soft
key. The Active:Conference screen will display again.
• To place a call to a new party, press the New Call soft key.
The conference remains on hold, and the new call
becomes the active call.
• To end the conference call and split the conference into
two separate calls on hold, press the Split soft key.
Splitting Conferences
When a conference has been established, a Split soft key is
available. When you split a conference, you end the conference
and put all parties on hold.
To split a conference:
From the Active:Conference screen, press the Split soft key.
The conference ends, and all calls are split into individual calls
and put on hold.
To Next Page
Loading...
